HP 2000CP 2500CP Manual de usuario descargar pdf (Pagina 250)

100

101

8-29 Removal and InstallationHP DesignJet CP Series Printers

Primer Assembly (Only Applicable to

HP DesignJets 2500CP/2000CP)

NOTE FOR HP DESIGNJETS 3500CP/3000CP: IF THE

PRIMER ASSEMBLY FAILS, YOU MUST REPLACE THE

COMPLETE SERVICE STATION.

Refer to figure 9  page 8-31

Removal



Switch off the printer and remove the power cord.

1. Remove the following:

1. Window and Top Cover  page 8-15.

2. Right Hand Cover  page 8-21.

2. Manually slide the carriage assembly to the middle of the printer.

3. Disconnect the 4 tubes (item 1) from the primer assembly (item 3).

4. Release the cables from the cable clamp located underneath the service

station assembly.

5. Remove the service station interconnect PCA from underneath the

service station assembly by releasing it from a retaining clip and sliding

it out.

6. Disconnect the primer stepper cable from position J8 PRIMER

STEPPER on the service station interconnect PCA.

7. Disconnect the primer sensor cable from the position J4 PRIMER

SENSOR on the service station interconnect PCA.

8. Remove the three T-15 screws (item 2) securing the Primer Assembly

(item 3) to the service station assembly (item 4).

9. Remove the primer assembly.

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 347 348

Comentarios a estos manuales

Sin comentarios

HP 2000CP 2500CP Manual de usuario Pagina 250

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo HP 2000CP 2500CP