HP 2000CP 2500CP Manual de usuario descargar pdf (Pagina 285)

8-64 Removal and Installation

HP DesignJet CP Series Printers

Refill Interconnect PCA

Refer to figure 23  page 8-65

Removal



Switch off the printer and remove the power cord.

1. Remove the following:

1. Left Hand Cover assembly  page 8-18.

2. Remove the top half of the elevator assembly by releasing it from two

retaining clips at the back and lifting up and to the left.

3. Carefully disconnect all cables (item 4) from the refill interconnect PCA.

4. Remove the refill interconnect PCA (item 1) by removing two T-20 screws

(item 2) installed through two support rings (item 3) and into the left

hand side chassis.

Installation

1. Install two T-20 screws (item 2) through the refill interconnect PCA and

the two supporting rings (item 3) into the left hand side chassis.

2. Connect all cables (item4) to the refill interconnect PCA.

3. Install the top half of the elevator assembly by securing it to two

retaining clips at the back and push down and to the right.

4. Install the following:

1. Left Hand Cover assembly  page 8-18.

5. Connect the power cord.

6. Perform the following service tests:

1. D11 Bail  page 4-7.

2. D08 Sensors  page 4-20.

3. D03 Carriage Axis (Y-axis)  page 4-12 .

4. D06 Refill  page 4-18.

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 347 348

Sin comentarios

HP 2000CP 2500CP Manual de usuario Pagina 285