HP PROCURVE 2300 Manual de usuario descargar pdf (Pagina 154)

143

Enhancements in Release F.04.08

Configuring Rapid Reconfiguration Spanning Tree (RSTP)

Note

Executing the spanning-tree command alone enables Spanning Tree. Executing the command with

one or more of the whole-switch RSTP parameters shown in the table on the previous page, or with

any of the per-port RSTP parameters shown in the table on page 144, does not enable Spanning Tree.

It only configures the Spanning Tree parameters, regardless of whether Spanning Tree is actually

running (enabled) on the switch.

Using this facility, you can completely configure Spanning Tree the way you want and then enable it.

This method minimizes the impact on the network operation.

Multiple parameters can be included on the same command line. For example, to configure a

maximum-age of 30 seconds and a hello-time of 3 seconds, you would issue the following command:

HP 2524 (config)# span max 30 hello 3

Syntax: Abbreviations:

spanning-tree

protocol-version <rstp | stp>

force-version <rstp-operation | stp-compatible>

priority <0 - 15>

maximum-age <6 - 40 seconds>

hello-time <1- 10 seconds>

forward-delay <4 - 30 seconds>

span

prot <rstp | stp>

forc <rstp | stp>

pri <0 - 15>

max <6 - 40>

hello <1 - 10>

forw <4 - 30>

Defaults: see the table on the previous page.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 269 270

Sin comentarios

HP PROCURVE 2300 Manual de usuario Pagina 154