HP PROCURVE 2300 Manual de usuario descargar pdf (Pagina 152)

141

Enhancements in Release F.04.08

Configuring Rapid Reconfiguration Spanning Tree (RSTP)

Figure 65. Example of the Spanning Tree Configuration Display

Enabling or Disabling RSTP. Issuing the command to enable Spanning Tree on the switch imple-

ments, by default, the RSTP version of Spanning Tree for all physical ports on the switch. Disabling

Spanning Tree removes protection against redundant network paths.

Syntax: [no] spanning-tree

Abbreviation: [no] span

This command enables Spanning Tree with the current parameter settings or disables Spanning Tree,

using the “no” option, without losing the most-recently configured parameter settings.

Enabling STP Instead of RSTP. If you decide, for whatever reason, that you would prefer to run

the IEEE 802.1D (STP) version of Spanning Tree, then issue the following command:

Syntax: spanning-tree protocol-version stp

Abbreviation: span prot stp

For the STP version of Spanning Tree, the rest of the information in this section does not apply. Refer

to the “Spanning Tree Protocol (STP)” section of your Switch Management and Configuration Guide

for more information on the STP version and its parameters.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 269 270

Sin comentarios

HP PROCURVE 2300 Manual de usuario Pagina 152