HP PROCURVE 2300 Manual de usuario descargar pdf (Pagina 25)

Enhancements in Release F.05.05 through F.05.70

Enhancements in Release F.05.05 through F.05.60

Configuring Per-Port LLDP Transmit/Receive

This command controls LLDP transmit/receive traffic on active ports.

For example, to disable LLDP on port 1, use the command:

ProCurve(config)# lldp admin-status 1 disable

Disable Auto-MDIX

The Auto-MDIX feature allows a user to connect 10/100 switch ports to either MDI or MDI-X devices

using a straight-through cable. In some situations it is desirable to disable this feature. Beginning

with release F.05.24 there is a global command, no auto-mdix, that disables Auto-MDIX for all ports

that are in auto-negotiation mode.

Restrictions:

■ works only on copper ports

■ requires the port be brought down to change to/from Auto-MDIX

■ applies globally to all ports

■ with Auto-MDIX disabled, ports set to auto-negotiate operate in MDI-X mode

Syntax lldp admin-status < port-list > < enable | disable >

enable: With LLDP enabled on the switch in the default LLDP

configuration, each port is configured to transmit/receive

LLDP packets. This option lets you enable the specified port(s)

to transmit/receive LLDP packets. (For versions F.05.59 and

earlier, inbound LLDP packets from neighbor devices are not

supported on 2500 series switches.)

disable: Disable LLDP packet transmit/receive on the specified

port(s).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 269 270

Sin comentarios

HP PROCURVE 2300 Manual de usuario Pagina 25