HP PROCURVE 2300 Manual de usuario descargar pdf (Pagina 215)

204

Enhancements in Release F.02.02

New Time Synchronization Protocol Options

HP2512(config)# timesync timep Selects TimeP.

HP2512(config)# ip timep manual 10.28.227.141 Activates TimeP in Manual

mode.

Figure 100. Example of Configuring Timep for Manual Operation

Changing the TimeP Poll Interval. This command lets you specify how long the switch waits

between time polling intervals. The default is 720 minutes and the range is 1 to 9999 minutes. (This

parameter is separate from the poll interval parameter used for SNTP operation.)

Syntax: ip timep dhcp interval < 1 . . 9999 >

ip timep manual interval < 1 . . 9999 >

For example, to change the poll interval to 60 minutes:

HP2512(config)# ip timep interval 60

Disabling Time Synchronization Without Changing the TimeP Configuration. The recom-

mended method for disabling time synchronization is to use the

timesync command. This halts time

synchronization without changing your TimeP configuration.

Syntax: no timesync

For example, suppose TimeP is running as the switch’s time synchronization protocol, with

DHCP as

the TimeP mode, and the factory-default polling interval. You would halt time synchronization with

this command:

HP2512(config)# no timesync

If you then viewed the TimeP configuration, you would see the following:

Figure 101. Example of TimeP with Time Sychronization Disabled

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 269 270

Sin comentarios

HP PROCURVE 2300 Manual de usuario Pagina 215