
Table 78 SSB codes returned by raidcom modify snapshot (continued)
raidcom modify snapshot
DescriptionError codeExecuting/AsyncError message
SSB2SSB1
A pair cannot be created because there are not enough free
shared memory space.
81022E10ExecutingCMDRJE
The command ends abnormally because other than the
raidcom add snapshot command is issued for the volume
other than the Fast Snap or Snapshot pair.
97002E10ExecutingCMDRJE
The command ends abnormally because the pair is in the
state of unacceptable the command.
97012E10ExecutingCMDRJE
The Fast Snap or Snapshot pair cannot be restored because
the volume is shared between the P-VOL of a Fast
97022E10ExecutingCMDRJE
Snap/Snapshot pair and the S-VOL of a Continuous Access
Synchronous pair.
The Fast Snap or Snapshot pair cannot be restored because
the volume is shared between the P-VOL of a Fast
97032E10ExecutingCMDRJE
Snap/Snapshot pair and the S-VOL of a Continuous Access
Journal pair.
The Fast Snap or Snapshot pair cannot be restored due to
one of the following reasons:
97042E10ExecutingCMDRJE
• Snapshot data of a restore target Fast Snap or Snapshot
pair is being obtained per consistency group.
• Snapshot data of a different pair whose primary volume
is the restore target P-VOL of a Fast Snap or Snapshot
pair is being obtained per consistency group.
An error occurred at the operation of Fast Snap due to one
of the following reasons:
98002E10ExecutingCMDRJE
• The LDEV number specified for the P-VOL or the S-VOL
is incorrect.
• The LDEV specified as the P-VOL or the S-VOL is not
paired.
• The pair of the specified P-VOL or the S-VOL is not ready
to perform the specified operation.
• The specified Snapshot ID (MU number) is wrong.
• The specified Snapshot ID (MU number) is already used.
• The specified pool is not in the usable status.
• The license capacity has exceeded the maximum.
• The control table for Fast Snap is depleted.
The specified LDEV is not defined.00002E20ExecutingCMDRJE
The command ends abnormally because an unmounted
volume is specified as the P-VOL of a Fast Snap or Snapshot
pair.
00082E20ExecutingCMDRJE
The command ends abnormally because the blocked volume
is specified as the P-VOL of a Fast Snap or Snapshot pair.
00092E20ExecutingCMDRJE
The command ends abnormally because the volume in
formatting operation is specified as the P-VOL of a Fast Snap
or Snapshot pair.
000A2E20ExecutingCMDRJE
The command ends abnormally because the shared memory
(FC, TPF, or Extension3) is not expanded for necessary
capacity.
81072E21ExecutingCMDRJE
Error messages and error codes 241
Comentarios a estos manuales