Hp NetRAID-4M Controller Manual de usuario descargar pdf (Pagina 27)

3-3

Working with Controllers

The CLI allows you to open a controller in the following modes:

■ Read/write

■ Read-only

■ Snapshot

Modes of Opening and Closing a Controller

The CLI allows you to open and close a controller on the supported

operating system using the following modes:

■ Read/write

■ Read-only

■ Snapshot

The following sections describe how to open a controller in these

three modes and how to close a controller.

Opening a Controller in Read/Write Mode

To open a controller in read/write mode on the supported operating

system, use the open command, as in the following example.

HPN0> open HPN0

Executing: open "HPN0"

Opening a Controller in Read-only Mode

To open a controller in read-only mode on the supported operating

system, use the open command with the /readonly switch, as in

the following example.

HPN0> open /readonly=TRUE HPN0

Executing: open /readonly=TRUE "HPN0"

If after opening a controller in read-only mode, you decide you want

write access to that controller, you can do so without closing and

reopening the controller. Simply specify the open command with

the /readonly switch set to FALSE, as in the following example:

HPN0> open /readonly=FALSE HPN0

Executing: open /readonly=FALSE "HPN0"

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 335 336

Sin comentarios

Hp NetRAID-4M Controller Manual de usuario Pagina 27