Hp NetRAID-4M Controller Manual de usuario descargar pdf (Pagina 297)

13-9

Working with Tasks

Before suspending a task, use the task list command to display

information about all tasks running on a controller, as in the

following example. In the example the Ta s k I D column indicates 107,

which means that task 107 is running on a controller, and the

Done% column indicates 50%, which means that the task is 50%

complete.

HPN0> task list

Executing: task list

Controller Tasks

TaskId Function Done% Container State Specific1 Specific2

------ -------- ------- --------- ----- --------- ---------

107 Scrub 50% 00 RUN 00000000 00000000

To suspend task 107, use the task suspend command, as in the

following example. In the example, the task suspend command

suspends the task with the task ID of 107.

HPN0> task suspend 107

Executing: task suspend 107

After executing the task suspend command, use the task list

command to verify that task 107 has been suspended, as in the

following example. In the example, the State column indicates SUS,

which means that task 107 has been suspended.

HPN0> task list

Executing: task list

Controller Tasks

TaskId Function Done% Container State Specific1 Specific2

------ -------- ------- --------- ----- --------- ---------

107 Scrub 60% 00 SUS 00000000 00000000

Resuming Tasks

The CLI’s task resume command allows you to resume one or all

tasks that are running on a controller.

This section provides an example that describes how to resume a

task.

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 335 336

Sin comentarios

Hp NetRAID-4M Controller Manual de usuario Pagina 297