HP HP ProCurve Series 6600 Especificaciones descargar pdf (Pagina 41)

2-17

Installing the Switch

Installation Procedures

Installing the Switch

2. Install the two rails (shipped in the rack mount kit) in the HP 10000 Series

cabinet.

With a posi-drive screwdriver, install two M6 (16-mm) screws and two M6

cage nuts (shipped in the rack mount kit) to attach each rail to the cabinet

rack as shown in the Figure 10. Ensure that the rails are at the same height

on each post.

Devices installed in a rack or cabinet should be mounted as low as

possible, with the heaviest device on the bottom and progressively lighter

devices installed above it.

Figure 2-13. Attaching Rails to an HP 100000 Series Cabinet Rack

3. Install the hold-down and mounting brackets on the switch. (The hold-

down and mounting brackets are shipped in the HP 10000 Series Cabinet:

Rack Mount Kit.)

Use a #1 Phillips (cross-head) screwdriver to attach the hold-down

brackets (shipped in the rack mount kit) and the mounting brackets

(shipped with the switch) with the M4 (8 mm) flat-head screws (shipped

with the switch).

Install a hold-down bracket with two M4 screws.

Install a mounting bracket with four M4 screws.

Figures 11, 12, and 13 show where to install the hold-down and mounting

brackets on a 6600 Switch chassis when either the port side or the power

side face the cold aisle.

Install two M6 screws to attach

each rail.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 115 116

Sin comentarios

HP HP ProCurve Series 6600 Especificaciones Pagina 41