HP HP ProCurve Series 6600 Especificaciones descargar pdf (Pagina 44)

2-20

Installing the Switch

Installation Procedures

Installing the Switch

• If you are installing a 6600 Switch with the power side facing the cold

aisle:

i. Install an M6 cage nut in the appropriate hole on each rack post.

Then slide the switch into the rack until the switch is fully inserted

and the mounting hole in each bracket lines up with the cage nut

in each rack post.

ii. Connect each power cord to a power supply and secure the cord

with a velcro strap. Then route each cord through the rack. (See

“Routing a power cord” on page 2-21 for examples.)

iii. Install the air plenum. (See “Installing an Air Plenum” on page 2-

21 for more information.)

Figure 2-18. Installing a 6600 Switch in a Power-Side HP 10000 Series Mounting

with an Air Plenum

iv. Use two M6 screws (one screw for each bracket) to tighten the

plenum and the mounting bracket to the rack.

Figure 2-19. Securing a 6600 Switch in an HP 10000 Series Mounting

In a power-side-front mounting (Option 1 or 2), slide the switch and plenum into the rails.

In a power-side-front mounting, install and

tighten an M6 screw on each side of the

plenum with the cage nut in the rack post.

(In a port-side-front mounting, no plenum

is used.)

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 115 116

Sin comentarios

HP HP ProCurve Series 6600 Especificaciones Pagina 44