HP HP ProCurve Series 6600 Especificaciones descargar pdf (Pagina 48)

2-24

Installing the Switch

Installation Procedures

Installing the Switch

5. Connect the Switch to a Power Source

Plug the power cord into the power connector on the back of the switch and

into a nearby AC power source.

Re-check the LEDs during the self-test as described in “LED Behavior” on page

2-7.

6. (Optional) Install Transceivers

You can install or remove a transceiver from a transceiver slot without having

to power off the switch. A 6600 Switch supports only HP ProCurve trans-

ceivers, including:

■ 1-Gigabit SFP (mini-GBIC)

■ 10-Gigabit SFP+

Notes ■ On 6600-24G, 6600-24G-4XG, and 6600-48G Switches, the four SFP slots

are shared with 10/100/1000Base-T RJ-45 ports. If an SFP transceiver is

installed in a slot, the associated RJ-45 port is disabled and cannot be used.

■ An SFP+ (10-GbE) transceiver is not supported in an SFP (1-Gigabit) slot

and does not function. The following event log message is generated:

“Transceiver type not supported by this port”.

Similarly, an SFP (1-Gigabit) transceiver is not supported in an SFP+ (10-

GbE) slot. The same event log message is generated, and the transceiver

does not function.

■ Ensure the network cable is NOT connected when you install or remove

a transceiver unless you are using a Direct Attach Cable (DAC).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 115 116

Sin comentarios

HP HP ProCurve Series 6600 Especificaciones Pagina 48