HP HP ProCurve Series 6600 Especificaciones descargar pdf (Pagina 53)

2-29

Installing the Switch

Installation Procedures

Installing the Switch

Configuring the Management Console

To set up a console to manage the switch through the Console port connection:

1. Configure the PC terminal emulator as a DEC VT-100 (ANSI) terminal or

use a VT-100 terminal.

2. Configure the terminal with the following settings:

• A baud rate from 1200 to 115200 (the switch senses the speed)

• 8 data bits, 1 stop bit, no parity, and flow control set to Xon/Xoff

• For the Windows Terminal program, disable (uncheck) the “Use

Function, Arrow, and C

trl Keys for Windows” option.

• For the Hilgraeve HyperTerminal program, select the “Terminal keys”

option for the “Function, Arrow, and C

trl Keys act as” parameter.

If you use a management console with different configuration settings, be sure

to reconfigure the settings on both the terminal and the switch in the following

order so that both configurations are compatible:

1. Reconfigure the switch and save the new settings.

2. Reconfigure the terminal and save the new settings.

3. Reboot the switch and re-establish the console session.

Setting Up an Out-of-Band Console Connection

To access a 6600 Switch through an out-of-band (Console port) connection,

follow these steps:

1. Configure the management console as described in “Configuring the

Management Console” on page 2-29.

2. For a direct console connection, connect the PC or terminal to the

Console serial port using the console cable shipped with the switch:

• A DB9-to-DB9 console cable and a DB9-to-RJ45 adapter are shipped

with the 6600-24G, 6600-24G-4XG Switches.

• A DB9-to-RJ45 console cable is shipped with the 6600-24XG, 6600-

48G, and 6600-48G-4XG Switches. For the DB9-to-RJ45 console cable

pinouts, see “RJ45-to-DB9 Console Cable Pinouts” on page 2-31.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 115 116

Sin comentarios

HP HP ProCurve Series 6600 Especificaciones Pagina 53