HP HP ProCurve Series 6600 Especificaciones descargar pdf (Pagina 46)

2-22

Installing the Switch

Installation Procedures

Installing the Switch

Mounting the Switch in a 2-Post Telco Rack

The accessory kit shipped with a 6600 Switch contains the parts used to mount

the switch in a 2-post telco rack:

■ Two mounting brackets for a 2-post telco rack

■ Eight M4 (8 mm) screws to attach the mounting brackets (four screws per

bracket)

■ Four 12-24 (5/8 inch) screws to attach the mounting brackets to a 2-post

telco rack (two screws per post)

The 12-24 screws shipped with the switch have the correct threading for

standard EIA/TIA open 19-inch racks.

Although the 2-post mounting brackets have multiple mounting holes and can

be rotated for different mounting options, HP ProCurve recommends that you

always mount a 6600 Switch in a 2-post telco rack in the balanced position

shown in Figure 2-21.

Figure 2-21. Mounting a 6600 Switch in 2-Post Rack

To mount a 6600 Switch in a 2-post telco rack, follow these steps:

1. Using a #1 Phillips (cross-head) screwdriver, install the 2-post mounting

brackets at the center of the switch with the M4 (8 mm) screws. Use four

screws per bracket.

2. Determine the height at which you want to mount the switch in the rack

and with the help of another person, lift the switch into place.

3. Insert and tighten the 12-24 (5/8-inch) screws to secure each 2-post

bracket to the rack. Use two screws per post.

4. Connect the power cords to the switch and secure the cords with a velcro

strap (as shown Figure 2-22) as follows:

a. Connect the power cord to the power supply.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 115 116

Sin comentarios

HP HP ProCurve Series 6600 Especificaciones Pagina 46