HP HP ProCurve Series 6600 Especificaciones descargar pdf (Pagina 61)

3-5

Getting Started With Switch Configuration

Where to Go From Here: Networked Connections

Getting Started With Switch

Configuration

■ Out-of-band networked connection through the dedicated Management

port on 6600-24XG, 6600-48G, and 6600-48G-4XG Switches

To use: Connect an RJ-45 network cable to the Mgmt port to manage a

6600 Switch via Telnet from a remote PC or UNIX workstation.

You must first configure the switch with an IP address and subnet mask

by using the out-of-band console connection (see “Minimal Configuration

Through the Out-of-Band Console Connection” on page 3-2) or through

DHCP/Bootp.

A networked out-of-band connection allows you to manage data network

switches from a physically and logically separate management network.

For more information on, refer to the “Network Out-of-Band Management

(OOBM)” appendix in the Management and Configuration Guide at

www.procurve.com/manuals.

■ In-band networked connection through a data port on the switch

To use: Connect a PC or UNIX workstation with a VT-100 terminal

emulator directly to a switch data port. Then access the switch via Telnet

from the workstation

You must first configure the switch with an IP address and subnet mask

by using the out-of-band console connection (see “Minimal Configuration

Through the Out-of-Band Console Connection” on page 3-2) or through

DHCP/Bootp.

For more information on in-band and out-of-band networked connections for

switch management, refer to “Using the IP Address for Remote Switch

Management” on page 3-6 and the Management and Configuration Guide at

www.procurve.com/manuals.

Management

Sessions

A 6600 Switch can simultaneously support one out-of-band serial console

session through the Console port and up to five in-band Telnet/TCP

(networked) sessions through data ports on the switch.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 115 116

Sin comentarios

HP HP ProCurve Series 6600 Especificaciones Pagina 61