HP HP ProCurve Series 6600 Especificaciones descargar pdf (Pagina 51)

2-27

Installing the Switch

Installation Procedures

Installing the Switch

To remove a transceiver that has a plastic tab or plastic collar, push the tab or

collar toward the switch until you see the transceiver release from the switch

(you will see it move outward), and then pull the transceiver from the slot.

To remove a the transceiver that has a wire bail, lower the bail until it is

horizontal, and then using the bail, pull the transceiver from the slot.

7. Connect the Network Cables

Connect the network cables, described under “Cabling Infrastructure” (page

2-5), from the network devices or your patch panels to the fixed RJ-45 ports

on the switch or to any transceivers you have installed in the switch.

Using the RJ-45 Connectors

To connect: Push the RJ-45 plug into the

RJ-45 jack until the tab on the plug

clicks into place. When power is on for

the switch and the connected device,

the Link LED for the port should light

to confirm a powered-on device (for

example, an end node) is at the other

end of the cable.

If the Link LED does not go on when the

network cable is connected to the port,

go to “Using LEDs to Diagnose an Error

Condition” on page 5-4 to troubleshoot

the problem.

To disconnect: Press the small tab on

the plug and pull the plug out of the

jack.

Connecting Cables to Transceivers

Note Each of the four SFP (mini-GBIC) slots is shared with an associated 10/100/

1000Base-T RJ-45 port. If an SFP transceiver is installed in a slot, the associ-

ated RJ-45 port is disabled.

If you have any transceivers installed in the switch, the type of network

connections you will need to use depends on the type of transceivers you have

installed. See Appendix B, “Cabling and Technology Information”, for infor-

mation on transceiver cabling.

Unshielded twisted-pair cable:

• Category 3, 4, or 5 for 10 Mbps ports

• Category 5 or better for 100 Mbps ports

• Category 5e or better for 1000 Mbps ports

Maximum distance: 100 meters

RJ-45

connector

Figure 2-25. Connecting RJ-45s

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 115 116

Comentarios a estos manuales

Sin comentarios

HP HP ProCurve Series 6600 Especificaciones Pagina 51

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo HP HP ProCurve Series 6600