HP PROCURVE 2520 Manual de usuario descargar pdf (Pagina 155)

100

101

Interface Access and System Information

Denying Interface Access by Terminating Remote Management Sessions

You can also execute a series of console commands and then save the

configuration and boot the switch. For example:

ProCurve(config)# console baud-rate speed-sense

Command will take effect after saving configuration and reboot

ProCurve(config)# console flow-control xon/xoff

Command will take effect after saving configuration and reboot

parameters.

ProCurve(config)# write memory

ProCurve(config)# reload

Save the

changes.

Boot the

switch.

Configure

the

individual

Figure 7-5. Example of Executing a Series of Console Commands

Denying Interface Access by Terminating

Remote Management Sessions

The switch supports up to five management sessions. You can use show ip ssh

to list the current management sessions, and kill to terminate a currently

running remote session. (Kill does not terminate a Console session on the

serial port, either through a direct connection or via a modem. It does not

affect the console on the standby module.)

Syntax: kill [< session-number >]

For example, if you are using the switch’s serial port for a console session and

want to terminate a currently active Telnet session, you would do the

following:

7-9

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 543 544

Comentarios a estos manuales

Sin comentarios

HP PROCURVE 2520 Manual de usuario Pagina 155

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP PROCURVE 2520