HP PROCURVE 2520 Manual de usuario Pagina 402

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 544
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 401
File Transfers
Copying Diagnostic Data to a Remote Host, PC or UNIX Workstation
Copying Diagnostic Data to a Remote
Host, PC or UNIX Workstation
You can use the CLI to copy the following types of switch data to a text file in
a destination device:
Command Output: Sends the output of a switch CLI command as a file on
the destination device.
Event Log: Copies the switch’s Event Log into a file on the destination
device.
Crash Data: software-specific data useful for determining the reason for
a system crash.
Crash Log: Processor-Specific operating data useful for determining the
reason for a system crash.
The destination device and copy method options are as follows (CLI key word
is in bold):
Remote Host via TFTP.
Serially connected PC or UNIX workstation via Xmodem.
Copying Command Output to a Destination Device
Syntax:
copy command-output < “cli-command” > tftp < ip-address > < filepath-
filename >
copy command-output <“cli-command”> xmodem
These commands direct the displayed output of a CLI
command to a remote host or to a serially connected PC or
UNIX workstation.
For example, to use Xmodem to copy the output of show config to a serially
connected PC:
A-28
Vista de pagina 401
1 2 ... 397 398 399 400 401 402 403 404 405 406 407 ... 543 544

Comentarios a estos manuales

Sin comentarios