Hp Hitachi Dynamic Link Manager Software Manual de usuario Pagina 262

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 746
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 261
3. Creating an HDLM Environment
238
2. If necessary, back up the application data residing on the md device.
3. If file systems have been mounted on the md device, unmount them.
4. Check the status of the md device.
Execute the following command to check the configuration of the md device:
# cat /proc/mdstat
Personalities : [raid1]
md0 : active raid1 sdh1[0] sdi1[1]
5238528 blocks [2/2] [UU]
unused devices: <none>
Make sure that md0 : active and that SCSI devices are displayed.
If
md0 : active is not displayed, activate the md device.
5. If you have already used a configuration file (
/etc/mdadm.conf), back up that
file.
Execute the following command to back up that configuration file:
# cp -pr /etc/mdadm.conf /etc/mdadm.conf.backup
6. Execute the following command to create a configuration file:
Even if a configuration file had already been used in step 5, you still need to create
a configuration file so that the md device will be managed by HDLM.
# echo "DEVICE /dev/sdh1
/dev/sdi1" >> /etc/mdadm.conf
# mdadm --detail --scan | grep -w "/dev/md0" >> /etc/
mdadm.conf
For sdh1 and sdi1, specify the SCSI devices displayed in step 4.
The following example shows the contents of the created configuration file:
The underlined part indicates the lines added in this step.
# cat /etc/mdadm.conf
DEVICE /dev/sdh1 /dev/sdi1
DEVICE /dev/sdf1 /dev/sdg1 /dev/sdh1 /dev/sdi1
ARRAY /dev/md0 level=raid1 num-devices=2
UUID=e39a6b15:32e48a5d:ca05f4db:25bc8af9
ARRAY /dev/md0 level=linear num-devices=1
UUID=426a9f1c:9cfa6310:6aa9a80b:11ea2102
Vista de pagina 261
1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 745 746

Comentarios a estos manuales

Sin comentarios