
2. HDLM Functions
49
#1
The severity levels are as follows:
3: Error, 4: Warning, 6: Informational
#2
If you use Ctrl + C to cancel the
DLMgetras utility for collecting HDLM error
information, audit log data indicating that the
DLMgetras utility has terminated
will not be output.
2.12.2 Requirements for Outputting Audit Log Data
HDLM can output audit log data when all of the following conditions are satisfied:
• The
syslog daemon is active.
• The output of audit log data has been enabled by using the HDLM command's
set operation.
However, audit log data might still be output regardless of the above conditions if, for
example, an HDLM utility is executed from external media.
#
#:
The following audit log data is output:
• Categories:
StartStop, Authentication, and ConfigurationAccess
• Severity: 6 (Critical, Error, Warning, or Informational)
• Destination: syslog (facility value:
user)
Notes:
Processing of the
dlmsetopt -inqr
command was successful.
6KAPL150
56-I
Processing of the
dlmsetopt -inqr
command failed.
3KAPL150
57-E
Processing of the
dlmupdatesysinit
command was successful.
6KAPL150
58-I
Processing of the
dlmupdatesysinit
command failed.
3KAPL150
59-E
Category Explanation Audit event Severity
#1
Message
ID
Comentarios a estos manuales