HP RP7 Retail System Model 7100 Manual de usuario descargar pdf (Pagina 203)

Data Editing

Programming Reference Guide

195

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:

1. Go to page 34 and scan the ENTER/EXIT barcode.

2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as

suf

fix) by scanning the appropriate barcode in the section "Label ID Control" on

page 34. Reference Figure 4 for Label ID positioning options

if multiple identification

features are enabled.

3. Scan a barcode to select the symbology for whic

h you wish to configure a custom

Label ID from the section "Label ID Symbology Selection −

1D Symbologies" on

page 35.

4. Determine the desired character(s) (you may

choose up to three) which will represent

the Label ID for the selected symbology.

5. Turn to the ASCII Chart on the inside back cover of this manual and find the equiva-

lent hex digits associated with your choice o

f Label ID. For example, if you wish to

select an equal sign (=) as a Label ID, the chart indicates its associated hex characters

as 3D. Turn to "Keypad" starting on page 223 and scan the barcodes representing the

hex characters determined. For the example given, the characters ‘3’ and ‘D’ would be

sca

nned. More examples of Label ID settings are provided in Table 34.

6. Scan the ENTER/EXIT barcode to exit Label ID entry.

7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.

This completes the steps to

configure a Label ID for a given symbology.

Figure 4. Label ID Position Options

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

Prefix SuffixLabel ID Label IDBar Code DataAim ID

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 243 244

Sin comentarios

HP RP7 Retail System Model 7100 Manual de usuario Pagina 203