HP RP7 Retail System Model 7100 Manual de usuario descargar pdf (Pagina 208)

References

200

HP Retail Integrated Barcode Scanner

Aiming Duration Time

Specifies the frame of time the aiming pointer remains on after decoding a label, when in

trigger single mode. The range for this setting is from 1 to 255 seconds in 1-second

increments.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the result with leading zeroes to yield three

digits. For example: 0 = 000, 5 = 005,

20 = 020, etc.

3. Go to page 53 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT AIMING DURATION TIME SETTING.

5. Scan the appropriate three dig

its from the keypad in Appendix D, Keypad, that repre-

sent the duration which was determined in the

steps above. You will hear a two-beep

indication after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcod

e to exit Programming

Mode.

This completes the procedure. See Table 37 for some examples of how to set this feature.

Table 37. Aiming Duration Time Setting Examples

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

STEP ACTION EXAMPLES

1 Desired Setting

1 Second 90 Sec. (1.5 min.) 180 Sec. (3 min.) 255 Seconds (4.25 min.)

2 Pad leading zero(es)

001 090 180 255

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT AIMING DURATION TIME SETTING

Scan Three Characters From

Appendix D, Keypad

‘0’, ‘0’ and ‘1’ ‘0’, ‘9’ and ‘0’ ‘1’, ‘8’ and ‘0’ ‘2’, ‘5’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 243 244

Sin comentarios

HP RP7 Retail System Model 7100 Manual de usuario Pagina 208