HP RP7 Retail System Model 7100 Manual de usuario descargar pdf (Pagina 205)

Data Editing

Programming Reference Guide

197

Character Conversion

Character conversion is an eight byte configuration item. The eight bytes are 4 character

pairs represented in hexadecimal ASCII values. The first character in the pair is the

character that will be converted. The second character in the pair is the character to convert

to. If the character to convert in a pair is FF, then no conversion is done.

For example, if you have the chara

cter conversion configuration item set to the following:

41423132FFFFFFFF

The first pair is 4142 or AB (41 hex is an ASCII

capital A, 42 hex is an ASCII capital B) and

the second pair is 3132 or 12 (31 hex is an ASCII 1, 32 is an ASCII 2). The other two pairs

are FFFF and FFFF.

With the label, AB12BA21, it would look as follows

after the character conversion:

BB22BB22.

The A characters were converted to B characters and the

1 characters were converted to 2

characters. Nothing is done with the last two character pairs, since they are all FF.

To set Character Conversion:

1. Go to page 40 and scan the ENTER/EXIT barcode.

2. Scan the “Configure Characte

r Conversion” barcode.

3. Determine the desired string. Sixteen positions must be determined as in

the above

example. Next, turn to the ASCII Chart on the inside back cover of this manual and

find the equivalent hex digits needed to

fulfill the string.

4. Turn to Appendix D, Keypad and scan the barcodes representing the hex characters

determined in the previous step.

5. Scan the ENTER/EXIT barcode to

exit Programming Mode.

If less than the expected string of 16 characters are selected, scan the ENTER/

EXIT barcode twice to accept the selections and exit Programming Mode.

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 243 244

Sin comentarios

HP RP7 Retail System Model 7100 Manual de usuario Pagina 205