
OLA/R Overview and Concepts
Planning and Preparation
Chapter 4100
Planning and Preparation
For the most part SMH prevents you from performing OLA/R procedures
that would adversly affect other areas of the server. This section provides
you with important information that can help minimize errors or
problems when performing OLA/R procedures.
Card Compatibility
On-Line Addition
When on-line adding an interface card, the first issue that must be
resolved is whether the new card is compatible with the system. Each
OLA/R-capable PCI slot provides a set amount of power. The
replacement card cannot draw more power than is available.
The card must also operate at the slot’s bus frequency. A PCI card must
run at any frequency lower than its maximum capability, but a card that
could only operate at 33 MHz would not work on a bus running at 66
MHz. rad provides information about the bus frequency and power
available at a slot, as well as other slot-related data.
On-Line Replacement
When on-line replacing an interface card, the replacement card must be
identical to the card being replaced. This is referred to as like-for-like
replacement and should be adhered to because using a similar but not
identical card may cause unpredictable results. For example, a newer
version of the target card which is identical in terms of hardware may
contain an updated firmware version that could potentially conflict with
the current driver.
The PCI specification allows a single physical card to contain more than
one function. A single-function SCSI bus adapter can not be replaced by
a dual-function adapter, even if the additional function on the card was
identical to the original SCSI bus adapter.
When the replacement card is added to the system, the appropriate
driver for that card must be configured in the kernel before beginning
the operation. SMH ensures the correct driver is present. (In most cases,
the replacement card will be the same type as a card already in the
system, and this requirement will be automatically met.) If you have any
Comentarios a estos manuales