HP CommonIO Products Manual de usuario descargar pdf (Pagina 160)

PAD Ser vices

PAD Commands

Chapter 6160

PAD Commands

PAD command signals are grouped into the X.28 PAD command set

(defined by CCITT X.28 recommendations) and include an extended

command set providing additional functionality.

X.28 PAD Command Set

clr

Clears a virtual circuit (VC), disconnecting the VC from

the remote host.

int

Transmits an interrupt to the remote host.

par?

Displays all of the X.3 parameters and their current

values. The format for the display is:

X.3 parameter number: current value

prof [profile_id]

Interprets a prepared set of command signals from a

profile. Profiles must be placed in the file

/etc/x25/x3config.

reset

Resets a virtual circuit (VC). When a VC is reset, all

data received (but unread) is lost, and all X.3

parameters are set to the default values (as they were

defined before the VC was established).

set n:v [,n:v]

Sets the X.3 parameter n to value v. If there is a syntax

error, padem responds with an ERR service signal and

updates the diagnostic text. All changes take effect

when a new VC is established, or immediately if one is

already established.

set? n:v [,n:v]

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 260 261

Sin comentarios

HP CommonIO Products Manual de usuario Pagina 160