HP CommonIO Products Manual de usuario descargar pdf (Pagina 115)

Diagnostic Utilities

x25check and x25server

Chapter 5 115

x25check and x25server

These commands are used together to test the connection between a

source node and a destination node, up to and including X.25

programmatic access level. x25check is a major tool for debugging the

X.25 subsystem and for checking the configuration for that subsystem.

x25server is a background process that waits for call requests from

x25check. The x25server must be running before you execute

x25check.

See the man pages for x25check and x25server for syntax and

parameter information.

NOTE The x25server daemon will be killed if all of the X.25 interfaces are

deactivated .

Example 1: Running x25check Interactively (No

Parameters)

The example below shows x25check used interactively to do three tests.

• The first test (sending a call packet only) is successful and the

results are shown. (Generally, when running x25check, first send

the CALL packet alone, without data, to verify that a VC has been

established between the nodes).

• The second test uses the same destination address to send five data

packets. Note that the X.121 address you enter becomes the default

value the next time your run the test.

• The third test (to a different X.121 address) is unsuccessful. An error

message stating the problem is displayed.

When x25check prompts you for a programmatic access name, press

Return. The programmatic access name is not used for 712 Series

workstations.

$ x25check

Test Starts on.. Wed Dec 8 09:13:41 1993

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 260 261

Sin comentarios

HP CommonIO Products Manual de usuario Pagina 115