HP CommonIO Products Manual de usuario descargar pdf (Pagina 252)

Diagnostic Messages

X.25 Diagnostic Messages

Appendix C252

160 (CLEAR,

RESET)

DTE-specific

signal (generic).

CALL INDICATION with reverse charge

requested has been received, and reverse charge

is configured to be rejected by system.

CALL INDICATION with reverse charge

requested has been received by IP and reverse

charge is configured to be rejected for that

IP/X.121 address pair. Check is done via IP to

X.121 address map table.

CALL INDICATION with reverse charge

requested has been received by IP and no entry

in the IP-to-X.121 address map table exists for

this X.121 address. Internal problem which may

be generated by components of X.25/9000

architecture.

161

(RESTART)

DTE

operational.

Level 2 is coming up or a SABM frame is

received. System sends RESTART REQUEST

indicating host is up.

162 (CLEAR,

RESET)

DTE not

operational.

Either level 3 or level 2 detected as down.

Request delivered when network interface was

not operational. Condition usually results in an

error returned to the application instead of

CLEAR. Diagnostic is used when RESTART

INDICATION has been received by interface.

Interface is going down. RESTART REQUEST

was sent on network.

163 (CLEAR,

RESET)

DTE resource

constraint.

Lack of memory to establish, reset, or clear a call,

to process data, expedite data or

acknowledgments, or to perform internal

operation. This may indicate lack of network

memory, or resource constraints on card. When

resource constraint appears on connected circuit,

CLEAR will be sent only if no recovery is

possible.

Table C-8 DTE-Specific Signals (Continued)

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 260 261

Comentarios a estos manuales

Sin comentarios

HP CommonIO Products Manual de usuario Pagina 252

Comentarios a estos manuales

Relacionado con productos y manuales para Redes HP CommonIO Products