HP CommonIO Products Manual de usuario descargar pdf (Pagina 145)

PAD Services

Remote PAD Printer Support (x29printd)

Chapter 6 145

Step 3. Configure the printer in the spooler system with the following

commands:

lpshut

lpadmin -v/dev/x29/x29printer1 -pfoo -mruggedwriter

lpsched

accept foo

enable foo

lpshut(1M) is necessary since lpadmin will not execute when lpsched is

running. You must restart LP scheduler after lpadmin. lpsched(1M)

schedules requests taken by lp(1) for line printing. After a printer is

configured in the spooler, you must enable it to accept printing requests.

Verifying the Configuration

After you complete the steps above, check the configuration as shown

below:

• lpstat -t should display the following (assuming that only this

printer is configured in the spooler system and you did these steps on

January 23, 11:00 am):

scheduler is running

no system default destination

device for foo: /dev/x29/x29printer1

foo accepting requests since Jan 23 11:00

printer foo is idle. enabled since Jan 23 11:00

fence priority : 0

• ps -ef should show that both lpsched and x29printd are running.

• /var/x25/log/x29printd/x29printd.log should have been

created and should contain information on the configuration of

/dev/x29/x29printer1.

• /var/x25/log/x29printd/x29printd.log should not contain any

configuration error messages.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 260 261

Sin comentarios

HP CommonIO Products Manual de usuario Pagina 145