HP Vectra 520 Guía de instalación descargar pdf (Pagina 105)

100

101

3-50 Hardware installation: Application Module (SNN/SNN-E)

553-4001-111 Standard 1.0 March 1997

2 Secure the Meridian MAX 8 for power down.

Refer to the

Meridian MAX 8 Maintenance and Diagnostics Guide

(NTP 553-4001-811), “Maintenance and Administration programs:

system shut down” chapter, “Restart and Power Down Utilities” section,

“Secure the System for Power Down” subsection, for more information.

3 Power down your system by flipping the power switch located to the left

of the AEM to the OFF position. Wait approximately 20 seconds.

4 Flip the power switch to the ON position.

The system displays the following at the maintenance console. (The

CPU card being configured [MVME167 or MVME177] appears in the

message instead of “xxx”. ) Your system messages may differ.

MVMExxx Debugger/Diagnostics Release Version 2.2 – 01/14/94

COLD Start

Local Memory Found =

xxxxxxx (&xxxxxxxx)

Note

: (The “xxxxxxx (&xxxxxxxx)” will be 04000000 (&67108864) for

SNN-E, 02000000 (&33554432) for SNN, and 01000000 (&16777216)

for IPE/IPE-E.)

5 If your card was preset in the factory, go to Step 8.

If your card was not preset in the factory, the following message

appears:

Autoboot in progress... To abort hit <BREAK>

6 Press the {BREAK} key.

Note:

{F5} on the VT520 and VT420 is equivalent to the {BREAK} key.

––Break Detected––

The following menu may be shown. If it does not appear, go to Step 8.

1) Continue System Start Up

2) Select Alternate Boot Device

3) Go to System Debugger

4) Initiate Service Call

5) Display System Test Errors

6) Dump Memory to Tape

Enter Menu #:

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 502 503

Comentarios a estos manuales

Sin comentarios

HP Vectra 520 Guía de instalación Pagina 105

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo HP Vectra 520