HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido descargar pdf (Pagina 23)

This chapter describes the available login methods and introduces the related concepts.

You can access the device through the console port or the Web interface at the first login. After login, you

can configure other login methods on the device, such as AUX, Telnet, and SSH.

Table 1 Login methods

in method Default settin

and confi

uration re

uirements

Logging in to the CLI:

• Logging in through the console

port for the first time

By default, login through the console port is enabled, no username or

password is required, and the user privilege level is 3.

• Logging in through Telnet

By default, Telnet service is disabled.

To use Telnet service, you only need to enable the Telnet server

function. After you enable the Telnet server function ,a user can log in

to the device through Telnet with the IP address 192.168.0.1/24 (the

IP address of interface GigabitEthernet 0/0), the username admin, the

password admin, and the user privilege level 3.

• Logging in through SSH

By default, SSH service is disabled. To use SSH service, complete the

following configuration tasks:

• Enable the SSH server function and configure SSH attributes.

• Assign an IP address to an interface of the device and make sure

the interface and the SSH client can reach each other. By default,

only interface GigabitEthernet 0/0 is assigned an IP address

(192.168.0.1/24) .

• Configure scheme authentication for VTY login users (scheme

authentication by default).

• Configure the user privilege level of VTY login users (0 by default).

Local login through the AUX port

By default, login through the AUX port is disabled. To enable AUX

password for the default password authentication mode, or change

the authentication mode and configure parameters for the new

authentication mode.

NOTE:

Support for this login method depends on the device model. For more

information, see "Configuring none authentication for AUX login."

Logging in to the Web interface

By default, you can log in to the Web interface of the device with the

IP address 192.168.0.1/24 (the IP address of interface

GigabitEthernet 0/0), the username admin, and the password admin.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 149 150

Comentarios a estos manuales

Sin comentarios

HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP 200 Unified Threat Management (UTM) Appliance Series