HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido descargar pdf (Pagina 60)

Ste

Command

Remarks

10. Specify the command level of

the local user.

authorization-attribute level level

No command level is configured

for the local user.

11. Specify the Telnet service type

for the local user.

service-type web

By default, the system-predefined

user admin can use terminal

service, Telnet service, SSH

service, and Web service, and no

service type is specified for any

other local user.

12. Exit to system view.

quit N/A

13. Enter interface view.

interface interface-type

interface-number

N/A

14. Assign an IP address and

subnet mask to the interface.

ip address ip-address { mask |

mask-length }

N/A

By default, only interface

GigabitEthernet 0/0 is assigned

an IP address (192.168.0.1/24).

Configuring HTTPS login

The device supports the following HTTPS login modes:

• Simplified mode—To make the device operate in this mode, you only need to enable HTTPS service

on the device. The device will use a self-signed certificate (a certificate that is generated and signed

by the device itself, rather than a CA) and the default SSL settings. This mode is simple to configure

but has potential security risks.

• Secure mode—To make the device operate in this mode, you must enable HTTPS service on the

device, specify an SSL server policy for the service, and configure PKI domain-related parameters.

This mode is more complicated to configure but provides higher security.

For more information about SSL and PKI, see Network management Configuration Guide and VPN

Configuration Guide.

Follow these guidelines when you configure HTTPS login:

• If the HTTPS service and the SSL VPN service use the same port number, they must have the same

SSL server policy. Otherwise, only one of the two services can be enabled.

• If the HTTPS service and the SSL VPN service use the same port number and the same SSL server

policy, disable the two services before you modify the SSL server policy, and re-enable them after

the modification. Otherwise, the SSL server policy does not take effect.

To configure HTTPS login:

Ste

Command

Remarks

1. Specify a fixed verification

code for Web login.

web captcha

verification-code

Optional.

By default, a Web user must enter the

verification code indicated on the login page

to log in.

This command is available in user view.

2. Enter system view.

system-view N/A

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 149 150

Comentarios a estos manuales

Sin comentarios

HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP 200 Unified Threat Management (UTM) Appliance Series