HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido descargar pdf (Pagina 57)

Logging in to the Web interface

The device provides a built-in Web server for you to configure the device through a Web browser. Web

Configuration guidelines

• The Web-based configuration interface supports the operating systems of Windows XP, Windows

2000, Windows Server 2003 Enterprise Edition, Windows Server 2003 Standard Edition,

Windows Vista, Windows 7, Linux, and MAC OS.

• The Web-based configuration interface supports the browsers of Microsoft Internet Explorer 6.0

SP2 and higher, Mozilla Firefox 3.0 and higher, Google Chrome 2.0.174.0 and higher, and the

browser must support and be enabled with JavaScript.

• The Web-based configuration interface does not support the Back, Next, Refresh buttons provided

by the browser. Using these buttons may result in abnormal display of Web pages.

• The Windows firewall limits the number of TCP connections, so when you use IE to log in to the Web

interface, sometimes you may be unable to open the Web interface. To avoid this problem, HP

recommends you to turn off the Windows firewall before login.

• If the software version of the device changes, clear the cache data on the browser before logging

in to the device through the Web interface; otherwise, the Web page content may not be displayed

correctly.

You can display at most 20,000 entries that support content display by pages.

Logging in by using the default Web login settings

By default, the HTTP service is enabled on the device and you can log in to the Web interface of the

device with the following default Web login settings:

• Username admin.

• Password admin.

• Management interface (GigabitEthernet 0/0) IP address 192.168.0.1.

If the HTTP service is disabled, you can enable it by following the steps provided in "Configuring HTTP

ou can use the default settings to log in to the Web interface by following these steps:

1. Connect a PC to the device's management interface GigabitEthernet 0/0 by using a crossover

Ethernet cable.

2. Change the IP address of the PC to one that in the network segment 192.168.0.0/24 (except for

192.168.0.1), for example, 192.168.0.2.

3. Configure routes to make sure the PC and device can communicate with each other properly.

4. Launch a Web browser on the PC, enter the IP address 192.168.0.1 in the address bar, and press

Enter to open the Web login page.

5. Enter the username, password, and verification code, and click Login. To get a new verification

code, click the verification code displayed on the Web login page.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 149 150

Sin comentarios

HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido Pagina 57