HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido descargar pdf (Pagina 58)

Up to five users can concurrently log in to the device through the Web interface.

Figure 46 Web login page

Adding a Web login account

Perform the following configuration at the CLI:

1. Add a Web user. Set the username to userA, password to 123456, and user privilege level to 3.

[HP] local-user userA

New local user added.

[HP-luser-userA] service-type web

[HP-luser-userA] password simple 123456

[HP-luser-userA] authorization-attribute level 3

[HP-luser-userA] quit

2. Add an interface to the management zone.

To allow users to log in to the device's Web interface through an interface other than the

management interface GigabitEthernet 0/0, you must add the interface to the management zone.

[HP] zone name management

[HP-zone-management] import interface gigabitethernet0/1

Configuring Web login

To enable Web login, log in through the console port, and perform the following configuration tasks:

• Enable HTTP or HTTPS service.

• Configure the IP address of a Layer 3 interface, and make sure the interface and the configuration

terminal can reach each other.

• Configure a local user account for Web login.

The device supports HTTP 1.0 and HTTPS for transferring webpage data across the Internet.

HTTPS uses SSL to encrypt data between the client and the server for data integrity and security, and is

more secure than HTTP. You can define a certificate attribute-based access control policy to allow only

legal clients to access the device.

HTTP login and HTTPS login are separate login methods. To use HTTPS login, you do not need to

configure HTTP login.

Table 10 sh

ows the basic Web login configuration requirements.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 149 150

Sin comentarios

HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido Pagina 58