HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido descargar pdf (Pagina 66)

On the host, run the IE browser, and then enter http://10.1.2.2/certsrv in the address bar and

request a certificate for the host as prompted.

3. Verify the configuration:

Enter https://10.1.1.1 in the address bar, and select the certificate issued by new-ca. When the

Web login page of the firewall appears, enter the username usera and password 123 to log in to

the Web management page.

For more information about PKI configuration commands, SSL configuration commands, and the

public-key local create rsa command, see VPN Command Reference and Network Management

Command Reference.

Troubleshooting Web browser

Failure to access the device through the Web interface

Symptom

You can ping the device successfully, and log in to the device through Telnet. HTTP is enabled and the

operating system and browser version meet the Web interface requirements. However, you cannot

access the Web interface of the device.

Analysis

• If you use the Microsoft Internet Explorer, you can access the Web interface only when the following

functions are enabled: Run ActiveX controls and plug-ins, script ActiveX controls marked safe for

scripting and active scripting.

• If you use the Mozilla Firefox, you can access the Web interface only when JavaScript is enabled.

Configuring the Internet Explorer settings

1. Open the Internet Explorer, and select Tools > Internet Options.

2. Click the Security tab, and then select a Web content zone to specify its security settings.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 149 150

Sin comentarios

HP 200 Unified Threat Management (UTM) Appliance Series Guía de inicio rápido Pagina 66