Hp Hitachi Dynamic Link Manager Software Manual de usuario Pagina 119

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 652
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 118
3. Creating an HDLM Environment
97
Integrated trace files after re-installation: /var/opt/hitachi/
HNTRLib2/spool/hntr2
n.log (n indicates a file number)
Trace files after re-installation:
/var/opt/DynamicLinkManager/log/
hdlmtrn.log
(n indicates a file number)
When you re-install HDLM 5.6 or later after uninstalling HDLM 04-01, or when
you perform an upgrade installation from HDLM 05-00 or later
Trace files before uninstallation:
/var/opt/hitachi/HNTRLib2/spool/hntr2n.log (n indicates a file
number)
Integrated trace files after upgrade installation or re-installation:
/var/opt/
hitachi/HNTRLib2/spool/hntr2
n.log (n indicates a file number)
Trace files after upgrade installation or re-installation:
/var/opt/
DynamicLinkManager/log/hdlmtr
n.log (n indicates a file number)
If you interrupted a new installation, check whether the /var/opt/
DynamicLinkManager
directory exists. If the /var/opt/
DynamicLinkManager
directory exists, execute the following command to
delete it:
# rm -rf /var/opt/DynamicLinkManager
If you interrupted an upgrade installation or re-installation, do not delete this
directory.
HDLM can be installed in a global zone only. If you install HDLM in a non-global
zone, the following message will be output and the installation will be interrupted:
KAPL09140-E HDLM cannot be installed in this zone. Install
it in the global zone.
Paths can be managed in a global zone only. To use HDLM devices in a
non-global zone, allocate HDLM devices from a global zone to the non-global
zone for each LU or for each controller. The following shows an example of
allocating the raw device of an HDLM device for
LU0 that is in a global zone to
a non-global zone, and then setting the configuration of the non-global zone from
the global zone.
Example:
# zonecfg -z zone1
zonecfg:zone1> add device
Vista de pagina 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 651 652

Comentarios a estos manuales

Sin comentarios