
6. Command Reference
386
Legend:
AFB: Automatic failback
IEM: Intermittent error monitoring
#1
When this condition is not satisfied, the KAPL01080-W message is output and an
error occurs. The status of intermittent error monitoring does not change.
#2
Because automatic failback is
off, intermittent error monitoring is disabled.
Example
The following example shows how to monitor for intermittent errors.
Change the IEM settings. • While a path is being monitored, the value of the
error count and the elapsed monitoring time are
reset to 0, and then intermittent error monitoring
will restart.
#1
• When a path is not being monitored, the IEM
settings will take effect again when the path is
recovered from the error status by performing an
automatic failback.
Set IEM to
off. • IEM is disabled.
• The error count, elapsed monitoring time, and
information about paths not subject to automatic
failbacks are cleared.
off Set AFB to on. The operations of AFB and IEM do not change.
Change the AFB setting. AFB operates using new settings.
Set AFB to
off.AFB is disabled.
Set IEM to
on.
IEM is enabled.
#1
off
on
#2
Set AFB to on.
AFB and IEM are enabled.
#1
Set AFB to off. The operations of AFB and IEM do not change.
off Set AFB to on. AFB is enabled.
Set AFB to off. The operations of AFB and IEM do not change.
Setting Executable operation Result of operation
AFB IEM
Comentarios a estos manuales