
2. HDLM Functions
46
#1
The severity levels are as follows:
3: Error, 4: Warning, 6: Informational
#2
If you use Ctrl + C to cancel the
DLMgetras utility for collecting HDLM error
information, audit log data indicating that the
DLMgetras utility has terminated
will not be output.
2.12.2 Requirements for Outputting Audit Log Data
HDLM can output audit log data when all of the following conditions are satisfied:
• The
syslog daemon is active.
• The output of audit log data has been enabled by using the HDLM command's
set operation.
However, audit log data might still be output regardless of the above conditions if, for
Processing of the
dlmsetconf [-d]
[-r] command was
successful.
6 KAPL15022-I
Processing of the
dlmsetconf [-d]
[-r] command failed.
3 KAPL15023-E
Processing of the
dlmsetconf [-d] -u
command was
successful.
6 KAPL15024-I
Processing of the
dlmsetconf [-d] -u
command failed.
3 KAPL15025-E
Processing of the
dlmvxexclude [-d]
command was
successful.
6 KAPL15026-I
Processing of the
dlmvxexclude [-d]
command failed.
3 KAPL15027-E
Category Explanation Audit event
Severity
#
1
Message ID
Comentarios a estos manuales