Hp Hitachi Dynamic Link Manager Software Manual de usuario Pagina 431

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 652
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 430
6. Command Reference
409
PathStatus Status of the displayed paths. The displayed status indicates the following:
Online: All paths are available.
Reduced: Some paths are not available.
Reduced means that some paths might have an error status, in which case you
should check the status of individual paths and resolve the problem for any paths
that have an error status.
IO-Count Total I/O count for the displayed paths, indicated by a decimal number. The
maximum value that can be displayed is 2
32
- 1 (4294967295). If the total I/O
count reaches the maximum value, it will re-start from 0.
IO-Errors Total I/O error count for the displayed paths, indicated by a decimal number. The
maximum value that can be displayed is 2
32
- 1 (4294967295). If the total I/O
error count reaches the maximum value, it will re-start from 0.
PathID The AutoPATH_ID indicated by a decimal number.
The AutoPATH_ID is assigned every time the host is restarted. When a new LU
was added and the host has not been restarted, AutoPATH_ID is re-assigned to
each path of the LU when you execute the
dlmcfgmgr utility for managing the
HDLM configuration.
PathName
#
-- The path name, which indicates a physical path. When you modify the system
configuration or replace a hardware item, you should check the path names to
identify the physical path that will be affected by the change.
Path name consists
of the following four elements, separated by periods:
Host port number (hexadecimal number)
Bus number (hexadecimal number)
Target ID (hexadecimal number)
Host LU number (hexadecimal number)
For details on each element of the path name and its representation in Solaris, see
Table 6-13: Elements of a Path Name.
DskName
#
DskName Storage system name, which identifies the storage system that is accessed by a
path.
A storage system name consists of the following three elements, separated by
periods:
Vendor ID: The name of the storage system vendor (for example,
HITACHI).
Product ID: Indicates the storage system product ID, emulation type, or
model ID (for example,
OPEN-3).
For more details on the storage system and corresponding product ID, see
Table 6-14: Product ID Displayed by the view -path Operation.
Serial number: The serial number of the storage system. For example,
0051.
You can identify an actual storage system by referencing the above information
from the storage system management program.
Displayed Item Description
No
summary
displayed
Summary
displayed
Vista de pagina 430
1 2 ... 426 427 428 429 430 431 432 433 434 435 436 ... 651 652

Comentarios a estos manuales

Sin comentarios