Hp Hitachi Dynamic Link Manager Software Manual de usuario Pagina 293

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 652
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 292
4. HDLM Operation
271
2. Execute the following HDLM command to place the paths online:
# /opt/DynamicLinkManager/bin/dlnkmgr online -s
Even if the paths are physically connected, this command may fail if executed
immediately after the boot processing completes. In this case, wait at least 10
seconds and then re-execute the command. If still unsuccessful, take the action
indicated in the displayed message.
3. Execute the following command to set the HDLM logical device file name in the
HDLM filter driver:
# /opt/DynamicLinkManager/bin/dlmsetdevname
4. Execute the following command to start the HDLM manager:
# /etc/init.d/DLMManager start
(2) Tasks that Can Be Performed in Single-User Mode
By executing the procedure described in (1) Initializing HDLM When the Host Is
Started in Single-User Mode, you can perform the following tasks in single-user mode
while applications are inactive.
For Solaris
You can perform the following tasks on the server on which HDLM is installed,
in the same manner as on a server without HDLM installed:
Apply patches
Add or delete packages
Change basic settings in Solaris, etc.
For HDLM
Installing HDLM
Configuring a boot disk environment
Setting up HDLM functions
Setting up an integrated trace
#
Creating a file system
Executing an HDLM command
Using an HDLM device
Vista de pagina 292
1 2 ... 288 289 290 291 292 293 294 295 296 297 298 ... 651 652

Comentarios a estos manuales

Sin comentarios