Hp Hitachi Dynamic Link Manager Software Manual de usuario Pagina 282

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 652
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 281
3. Creating an HDLM Environment
260
virtual disk backends from the service domain on the I/O domain to which HDLM
will be installed.
For example, to export virtual disk backends
vol1 and vol2 from the service
domain
ldg1, execute the command as follows:
# ldm add-vdsdev /dev/dsk/c2t50060E8010027A82d0s2
vol1@ldg1-vds0
#
# ldm add-vdsdev /dev/dsk/c2t50060E8010027A82d1s2
vol2@ldg1-vds0
#
#
/dev/dsk/c2t50060E8010027A82d0s2 and /dev/dsk/
c2t50060E8010027A82d1s2
are sd or ssd device names after exporting.
9. On the control domain, execute the
ldm add-vdisk command to assign the
virtual disk backends to the guest domain.
For example, to assign the virtual disk backends
vol1 and vol2 exported from
the service domain
ldg1 to the guest domain ldg2, execute the command as
follows:
# ldm add-vdisk vdisk1 vol1@ldg1-vds0 ldg2
# ldm add-vdisk vdisk2 vol2@ldg1-vds0 ldg2
10. On the control domain, execute the ldm bind command to bind (connect) the
resource of the guest domain
ldg2.
For example, to bind (connect) the resource of the guest domain
ldg2, execute
the command as follows:
# ldm bind ldg2
11. On the control domain, execute the ldm start command to start the guest
domain.
For example, to start the guest domain
ldg2, execute the command as follows:
# ldm start ldg2
A configuration example after uninstalling HDLM is shown in
Figure 3-31: Configuration Example (After Uninstallation).
Vista de pagina 281
1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 651 652

Comentarios a estos manuales

Sin comentarios