Hp Hitachi Dynamic Link Manager Software Manual de usuario Pagina 167

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 652
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 166
3. Creating an HDLM Environment
145
3. Set the LU slices to be used by the post-migration boot disk.
4. Execute the
dlmsetconf utility as follows to create the HDLM driver
configuration definition file (
/kernel/drv/dlmfdrv.conf) and the HDLM
driver unconfiguration definition file (
/opt/DynamicLinkManager/config/
dlmfdrv.unconf
):
# /opt/DynamicLinkManager/bin/dlmsetconf
This step and the next step set the LU to be used for the post-migration boot disk
as an HDLM-managed LU.
5. Restart the host with the reconfiguration option specified to make the settings
valid and the HDLM device recognizable.
Execute one of the following commands:
# reboot -- -r
boot -r (at the ok prompt)
After you finish these steps, perform the procedure described in (5) Setting Up the
Post-Migration Environment.
(2) Migration by Installing HDLM in the Existing Local Boot Disk Environment
Perform the steps below in the pre-migration environment. The workflow is shown in
Figure 3-9: Flow of setting up the boot disk environment when installing HDLM in
the existing local boot disk environment.
Vista de pagina 166
1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 651 652

Comentarios a estos manuales

Sin comentarios