Hp Hitachi Dynamic Link Manager Software Manual de usuario Pagina 161

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 652
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 160
3. Creating an HDLM Environment
139
3. Execute the ldm unbind command to unbind the resource of the guest domain.
For example, to unbind a resource of the guest domain
ldg2, execute the
command as follows:
# ldm unbind ldg2
4. Execute the ldm rm-vdisk command to remove virtual disks from the guest
domain.
For example, to remove virtual disks
vdisk1 and vdisk2 from the guest domain
ldg2, execute the command as follows:
# ldm rm-vdisk vdisk1 ldg2
# ldm rm-vdisk vdisk2 ldg2
5. Execute the ldm rm-vdsdev command to stop exporting virtual disk backends
from the service domain on the I/O domain to which HDLM will be installed.
For example, to stop exporting virtual disk backends
vol1 and vol2 from the
service domain
ldg1, execute the command as follows:
# ldm rm-vdsdev vol1@ldg1-vds0
# ldm rm-vdsdev vol2@ldg1-vds0
6. Log in to the I/O domain.
7. Install HDLM in the I/O domain.
Use the virtual disk backends exported before installing HDLM to perform the
following operations:
For a physical disk and physical disk slice
No action is required.
For a UFS or VxFS file system
Unmount the file system.
For a ZFS file system
Export the ZFS file system.
For a VxVM logical volume
Deport the disk group.
For an SVM logical volume
Cancel the volume group setting.
For details on the HDLM installation procedure, see 3.5.3 Performing a New
Installation of HDLM (When Sun Cluster Is Not Being Used) or 3.5.7 Performing
an Upgrade Installation or Re-installation of HDLM After installing HDLM,
restore the volume group and file system that will be used as the virtual disk
Vista de pagina 160
1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 651 652

Comentarios a estos manuales

Sin comentarios