HP Web Jetadmin Software Manual de usuario descargar pdf (Pagina 335)

To specify the default media type, select the media type from the drop-down list.

Default Print Density

This option lets you select the default density for print jobs, which aects all pages printed on the device (host

print jobs, received faxes, copies, and internal reports).

To select this option, select a density from the drop-down box (5 is the darkest, or highest density). For color,

select the desired print density for each color. If applicable, you can also select the print density for highlights,

midtones, and shadows.

Default Printer Copies

This option lets you specify the default number of copies that are printed for each print job. This option is useful

if the people who use the printer typically print a specic number of copies. For example, if the printer is

dedicated to the legal department and those users always print three copies of their documents, set the default

number of copies to three.

NOTE: The copies setting that you select when printing a job overrides the setting specied here.

To specify the default number of printer copies, type the number of copies into Default Printer Copies.

Delay Calibration at Wake/Power On

Use this option to control the timing of the calibration when the printer wakes up or is turned on.

Use the following steps to congure this option:

1. To set the printer to calibrate immediately when it wakes up or is turned on, select O. The device will not

print any jobs until it nishes calibrating.

2. To enable a device that is asleep to accept print jobs before it calibrates, select On. The device only accepts

new jobs for a short time. It may start calibrating before it has printed all the jobs it has received.

NOTE: For best results, allow the device to calibrate before printing. Print jobs performed before calibration

might not be of the highest quality.

Device Certicates

Devices use certicate authority (CA) certicates, which are also called public keys, to browse to external

websites. For example, devices might require a CA certicate to enable OXPd 1.6 support. If there are no CA

certicates in the device’s certicate store, the device uses the HP Jetdirect CA certicate if one is available.

Use this option to install or remove the Secure Sockets Layer (SSL) trusted CA certicates on the device.

Install or remove CA certicates on the device

When CA certicates are removed from the device, the CA certicates remain in the HP Web Jetadmin Certicate

Repository.

CAUTION: If an intermediate CA certicate is installed, the scope of authentication is limited.

ENWW Device Conguration Options for Device 309

1 2 ... 330 331 332 333 334 335 336 337 338 339 340 ... 491 492

Sin comentarios

HP Web Jetadmin Software Manual de usuario Pagina 335