HP Web Jetadmin Software Manual de usuario descargar pdf (Pagina 430)

CAUTION: To prevent potential problems, make sure that the address you assign is not already in use.

NOTE: While the Novell protocol environment on the HP Jetdirect print server can restart and begin printing

again after you assign locally administered addresses, you must recongure the other protocol environments to

acknowledge the new address. This includes the Linux and Microsoft host software.

NOTE: You can only apply this conguration option to a single device. You cannot use this conguration option

to congure multiple devices at one time or include this conguration option in a template.

To assign or change the locally administered address, type the address in the text box.

Link Setting

Use this option to specify the link speed (10 or 100 Mbps) and the communication mode (full- or half-duplex)

that the device should use when connecting to your 10/100Base-TX network each time it is powered on. To

communicate on your network, the device link speed and communication mode must match the operation of

your network. If the device setting is AUTO, the device will attempt to autonegotiate its link settings with the

network each time it is powered on. If the device successfully links to the network, you can then use this feature

to explicitly congure the required link setting on the device. When the device is powered on again, the

congured setting will be used directly. However, if the device fails to link using AUTO, then the link settings on

the device will default to 100 Mbps and half-duplex mode. Communications with the device over the network

may, or may not, be possible. The link setting options:

●

AUTO: Link settings are automatically negotiated.

●

10TXFULL: The link is set to 10 Mbps, full-duplex operation.

●

10TXHALF: The link is set to 10 Mbps, half-duplex operation.

●

100TXFULL: The link is set to 100 Mbps, full-duplex operation.

●

100TXHALF: The link is set to 100 Mbps, half-duplex operation.

●

1000TFULL: The link is set to 1000 Mbps full-duplex operation.

NOTE: Setting the link to a setting incompatible with the network causes the printer to lose access to the

network and might require a cold reset of the printer.

To congure this option, select one of the Link Setting options from the drop-down box.

Mgmt Protocol

Use this option to enable and disable the Transport Layer Security (TLS) and Secure Sockets Layer (SSL)

protocols that the device uses to provide communication security and encryption over the Internet.

Federal Information Processing Standard (FIPS) supports only the TLS 1.0, TLS 1.1, and TLS 1.2 protocols. To

congure the security protocol when FIPS mode is enabled on the device, you must specify the TLS 1.0, TLS 1.1,

and TLS 1.2 protocols. If you specify the SSL 3.0 protocol, the conguration fails.

If you congure only the SSL 3.0 protocol for a device, a discovery nds the device and adds the device to the

device lists, but the device is in a Device Communication Error state.

To enable a protocol, select the corresponding checkbox.

To disable a protocol, clear the corresponding checkbox.

404 Chapter 6 Device Conguration Options ENWW

1 2 ... 425 426 427 428 429 430 431 432 433 434 435 ... 491 492

Comentarios a estos manuales

Sin comentarios

HP Web Jetadmin Software Manual de usuario Pagina 430

Comentarios a estos manuales

Relacionado con productos y manuales para Multifuncionales HP Web Jetadmin Software