HP Compaq Professional 5000 series Guía para resolver problemas descargar pdf (Pagina 62)

Quick Troubleshooting Guide

B-1

appendix

POST E

RROR

ESSAGES

- N

UMBERED

Some Compaq computers have a complete series of POST error messages with code numbers

assigned to them. Use the information below for those computers.

An error message results if the Power-On Self-Test (POST) encounters a problem. This test runs

when the system is turned on, checking assemblies within the computer and reporting any errors

found.

Screen Message Beeps* Probable Cause Recommended Action

101-Option ROM Error 1L, 1S System ROM checksum. 1. Verify the correct ROM.

2. Flash the ROM if needed.

3. If an expansion card was

recently added, remove it and

see if the problem remains.

4. Clear CMOS.

5. If the message disappears,

there may be a problem with

the expansion card.

6. Replace the system board.

102-System Board

Failure

None DMA, timers, etc. 1. Clear CMOS.

2. Remove expansion boards.

3. Replace the system board.

103-System Board Failure None DMA, timers, etc.

1. Clear CMOS.

2. Remove expansion boards.

3. Replace the system board.

150-SafePost Active None A PCI expansion card is not

responing.

1. Restart the computer.

2. Disable SafePost.

3. If the expansion card does not

respond, replace the card.

162-System Options

Not Set

2S Configuration incorrect.

RTC (real-time clock)

battery may need to be

replaced. Battery life is

approximately 3 years.

Run Computer Setup (F10 Setup)

Reset the date and time under

Control Panel. If the problem

persists, replace the RTC battery.

* L = Long, S = Short

continued

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 73 74

Comentarios a estos manuales

Sin comentarios

HP Compaq Professional 5000 series Guía para resolver problemas Pagina 62

Comentarios a estos manuales

Relacionado con productos y manuales para Madre De Los Servidores / Estaciones De Trabajo HP Compaq Professional 5000 series