HP Compaq Professional 5000 series Guía para resolver problemas descargar pdf (Pagina 70)

Quick Troubleshooting Guide

B-9

POST Error Messages

Continued

Screen Message Beeps* Probable Cause Recommended Action

1793-Secondary Controller

or Disk Failure

None Hard drive circuitry error. 1. Run Computer Setup (F10

Setup).

2. Clear CMOS.

3. Check cable seating /jumper

settings.

4. Run hard drive diagnostics.

5. Disconnect additional drives.

6. Run the Drive Protection

System test if available.

7. Replace the hard drive.

1800-Temperature Alert None Internal temperature

exceeds specification.

1. Check that computer air vents

are not blocked and cooling fan

is running.

2. Verify processor speed

selection.

3. Replace the processor.

4. Replace the system board.

1801 None Processor not supported by

ROM Bios.

Upgrade Bios to proper version.

Audible 1L, 3S System ROM is bad;

system is running in

Failsafe Boot Block mode.

Reflash the ROM using a ROMPaq

diskette. Refer to the “Failsafe Boot

Block ROM” section of the

Software

Reference Guide

Audible 2S Power-on successful. None

Flashing Caps Lock LED

on Keyboard

1L, 2S Graphics controller not

present or incorrectly

initialized.

1. Clear CMOS.

2. If graphics card has been

added, remove and reseat.

Flashing Num Lock LED on

Keyboard

1S, 2L System memory not

present.

1. Check memory module.

2. Remove and reseat memory

module.

3. See “Memory Problems” in

Appendix A.

Num Lock LED on

Keyboard

None Failed Boot Block. Reflash the ROM using a ROMPaq

diskette.

Flashing Scroll Lock LED

on Keyboard

2L, 1S System board hardware

failure (prior to video).

Replace system board.

* L = Long, S = Short

continued

1 2 ... 65 66 67 68 69 70 71 72 73 74

Comentarios a estos manuales

Sin comentarios

HP Compaq Professional 5000 series Guía para resolver problemas Pagina 70

Comentarios a estos manuales

Relacionado con productos y manuales para Madre De Los Servidores / Estaciones De Trabajo HP Compaq Professional 5000 series