HP Compaq Professional 5000 series Guía para resolver problemas Pagina 73

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 74
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 72
C-2
Post Error Messages - Not Numbered
Error message Probable Cause Recommended Action
Diskette Drive A or B Error Drive A: or B: is present, but
fails the BIOS POST diskette
tests.
1. Run Setup.
2. Replace the signal cable.
3. Replace the drive.
Extended RAM Failed at
Offset,
nnn
Extended memory is not
working or is not configured
properly.
1. Replace the memory modules.
2. Replace the system board.
Failing Bits
nnn nnn
is a map of the bits at the
RAM address which failed the
memory test.
1. Run Setup.
2. Replace the system board.
Fixed Disk 0 or 1 Failure Hard drive is not working or is
not configured properly.
1. Run Setup.
2. Replace the signal cable.
3. Replace the hard drive.
Fixed Disk Controller
Failure
Hard drive is not working or is
not configured properly.
1. Run Setup.
2. Replace the system board.
Incorrect Drive A Type Type of diskette in drive A: is
not correctly identified.
1. Run Setup.
2. Replace the diskette drive.
Invalid NVRAM Media Type Problem with NVRAM
(CMOS) access.
Replace the system board.
Keyboard Controller Error Keyboard, I/O keyboard
controller (on system board),
or mouse error.
1. Replace the keyboard.
2. Replace the mouse.
3. Replace the system board.
Keyboard Error Keyboard, I/O keyboard
controller (on system board),
or mouse error.
1. Replace the keyboard.
2. Replace the mouse.
3. Replace the system board.
Operating System Not
Found
Operating system cannot be
located on either drive A: or
C:.
Run Setup.
Parity Check 1 Parity error found in the
system bus.
1. Run Setup.
2. Replace the memory modules.
3. Replace the system board.
Parity Check 2 Parity error found in the I/O
bus.
1. Run Setup.
2. Replace the ISA board
(modem).
Real Time Clock Error Real-time clock fails BIOS
test.
Replace the system board.
System Battery is Dead RTC battery is dead.
1. Replace the RTC battery.
2. Run Setup.
Continued
Vista de pagina 72
1 2 ... 68 69 70 71 72 73 74

Comentarios a estos manuales

Sin comentarios