Hp ESL E-series Tape Libraries Manual de usuario descargar pdf (Pagina 135)

Message name / descriptionASCQASCSense

key

OVERLAPPED COMMANDS ATTEMPTED

Due to a second command being sent from the same host before a

previous command has completed, the previous command has been

aborted. This may also occur when executing off-line commands via the

control panel and DIAG port simultaneously.

• Verify that the host software application is supported, has up-to-date

patches, and is correctly configured.

• Verify that the library and its components have the current firmware.

004E5

UNCALIBRATED POSITION

System requires calibration. Run the Calibrate Cabinet test from the OCP.

028A5

CLM INVALID START CONDITION

CLM hardware condition is unknown. Run the Robotics to Home Position

test.

E08B5

CLM INVALID COMMAND

CLM hardware commanded to position out of system mechanical limits.

• Run the Robotics to Home Position test.

• If the problem persists, calibrate the library.

F08B5

IMPORT OR EXPORT ELEMENT ACCESSED

Load port door has been closed.

012B6

POWER-ON, RESET OR BUS DEVICE RESET OCCURRED

Informational message. The host user should assume the inventory may

have changed, and should ask the library for that information again.

00296

POWER-ON RESET OCCURRED.

Informational message. The host user should assume the inventory may

have changed, and should ask the library for that information again.

01296

BUS RESET OCCURRED.

Informational message. The host user should assume the inventory may

have changed, and should ask the library for that information again.

02296

BUS DEVICE RESET OCCURRED

Informational message. The host user should assume the inventory may

have changed, and should ask the library for that information again.

03296

INTERNAL DEVICE RESET OCCURRED

Informational message. The host user should assume the inventory may

have changed, and should ask the library for that information again.

04296

DOOR WAS OPENED INVENTORY MAY HAVE BEEN CORRUPTED

Close door and retry command after inventory is complete.

00806

SYSTEM STOP BUTTON WAS PRESSED

The STOP button on the control panel was pressed. Press the STOP button

again to start the cabinet. Retry command.

07806

HP StorageWorks ESL E-Series Tape Library 135

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 175 176

Comentarios a estos manuales

Sin comentarios