
Drive cage
Follow these steps to remove the drive cage:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 28).
2. Remove the access panel (see Access panel on page 29).
3. Disconnect all power cables and data cables from the hard drives installed in the drive cage (see Hard
drives on page 32).
4. Press down on the drive cage release tab (1).
5. Lift the right side of the drive cage (2) until it rests at an angle.
6. Slide the drive cage (2) up and to the right at an angle and remove it.
Reverse this procedure to install the drive cage.
34 Chapter 4 Removal and replacement procedures
Comentarios a estos manuales