HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 96)

Control panel message Description Recommended action

302-Hard Disk 2: SMART Hard Drive Detects

Imminent Failure

Hard drive is about to fail. (Some hard drives

have a hard drive rmware patch that will x an

erroneous error message.)

1. Determine if hard drive is giving correct

error message. Run the Drive Protection

System test under using F2 Diagnostics

when booting the computer.

2. Apply hard drive rmware patch

if applicable. (Available at

http://www.hp.com/support.)

3. Back up contents and replace hard drive.

309 – 30C: Hard Disk 3–6: SMART Hard Drive

Detects Imminent Failure

Hard drive is about to fail. (Some hard drives

have a hard drive rmware patch that will x an

erroneous error message.)

1. Determine if hard drive is giving correct

error message. Run the Drive Protection

System test under using F2 Diagnostics

when booting the computer.

2. Apply hard drive rmware patch

if applicable. (Available at

http://www.hp.com/support.)

3. Back up contents and replace hard drive.

3F0–Boot Device Not Found Boot device not found. Insert boot device or load operating system.

3F1–Hard Disk 1 Error Hard disk 1 error. 1. Check and/or replace cables.

2. Clear CMOS. (See Password security and

resetting CMOS on page 92.)

3. Replace the hard disk drive.

3F2–Hard Disk 2 Error Hard disk 2 error. 1. Check and/or replace cables.

2. Clear CMOS. (See Password security and

resetting CMOS on page 92.)

3. Replace the hard disk drive.

400-Serial Port A Address Conict Detected Both external and internal serial ports are

assigned to the same resources.

1. Remove any serial port expansion cards.

2. Clear CMOS. (See Password security and

resetting CMOS on page 92.)

3. Recongure card resources and/or run

Computer Setup or Windows utilities.

401-Serial Port B Address Conict Detected Both external and internal serial ports are

assigned to the same resources.

1. Remove any serial port expansion cards.

2. Clear CMOS. (See Password security and

resetting CMOS on page 92.)

3. Recongure card resources and/or run

Computer Setup or Windows utilities.

402-Serial Port C Address Conict Detected Both external and internal serial ports are

assigned to the same resources.

1. Remove any serial port expansion cards.

2. Clear CMOS. (See Password security and

resetting CMOS on page 92.)

3. Recongure card resources and/or run

Computer Setup or Windows utilities.

403-Serial Port D Address Conict Detected Both external and internal serial ports are

assigned to the same resources.

1. Remove any serial port expansion cards.

2. Clear CMOS. (See Password security and

resetting CMOS on page 92.)

3. Recongure card resources and/or run

Computer Setup or Windows utilities.

88 Chapter 7 POST error messages and diagnostic front panel LEDs and audible codes

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 123 124

Comentarios a estos manuales

Sin comentarios

HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario Pagina 96

Comentarios a estos manuales

Relacionado con productos y manuales para No HP ProDesk 600 G4 Base Model Small Form Factor PC